|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
As the only source for this manual it rather rank quite high since it is well scanned and perfectly readable.
 ;
the manual is in good quality and it's in pdf. manual was send in less then 24h.
regards
mike
;
I would not plug this machine in without finding a manual like this. In addition to setup and normal operating instructions, it has troubleshooting flowcharts, diagrammed mechanical adjustments, and schematics to beat the band. The tech I hand it to would be thrilled to find solder side PCB diagrams with component outlines superimposed, pinouts for every IC chip, and line drawings of transistors, with labeled legs.
As for printing quality, this may be a copy of a copy, but even the finest print when enlarged is very legible. There is a bit of grayed print over a few pages, as if a wet page were placed over it, but the print is still very legible. If you could borrow an original manual and get it printed and bound for 4 to 6 times the cost, you could get better quality. In that case you wouldn't be here. For price, utility, and availability I am rating this manual highly.
;
I received the Manual in a timely manner and it was exactly what I needed.
This is a perfect copy of the Service Manual, The quality is great. I am very
happy. Thank you
;
exactly as they say. Within 24 hours the link to the pages and offcourse it was the right service manual. Super and thanks
HP J06-59992A Time Interval Calibrator
Theory of Operation
B1
1-1
'
OUTPUT A In-phase OUTPUT B OUTPUT A In-phase/Swap P2 OUTPUT B OUTPUT A Out-of-phase OUTPUT B OUTPUT A Out-of-phase/Swap OUTPUT B
Figure 4-1. HP-1B Command Swnmary.
4-7. INPUT SIGNAL CONVERSION
INPUT
SPLITTER B2 Zero SPLITTER B3 INPUT
B4
180
P2
171
SPLITTER N2
eg
The zero degree power-splitter divides the input signal into two nearly inphase output signals, PI and P 2 Command "Bl" routes the input signal from P l to Output A and P2 to Output B;'732"routes the input from P1 to Output B and P2 to Output A Similarly, the 180-degree power-splitter divides the input into two nearly out-of -phase signals, N 1 and N2. Command "B3" routes the input signal from N 1 to Output A and N2 to Output 8; '%4" routes the input from N 1 to Output B and N2 to Output A Refer to Figure 4- 1 for a diagram illustrating the effect of the HP-IB commands. The commands "Bl -B4",(or switches 1-4 if manually operated), result in four binary states defined by the two bits arriving on A D 4 pin 4 and pin 6. The bit from pin 4, via buffers in A2U 1 energizes the appropriate relays A2K 1 and A2K2, routing the incoming signal from A2J1 to the desired powersplitter. The outputs of the selected splitter are fed to A2K3 where they are connected to Outputs A and B directly, or reversed through a cross-over K3 relay arrangement. Note that the input signal to the splitters and the output signals from the splitters are ac-coupled via blocking capacitors A2C 1, C8, and C9. Table 4- 1 summarizes the J06-59992A operation.
Page 4-2
www.hparchive.com
|
|
|
> |
|
